 |
|
| If you can't view the Datasheet, Please click here to try to view without PDF Reader . |
|
|
|
| If you can't view the Datasheet, Please click here to try to view without PDF Reader . |
|
|
| Datasheet File OCR Text: |
| CONDUCTIVE POLYMER ALUMINUM SOLID ELECTROLYTIC CAPACITORS LF Radial Lead Type, Standard series Ultra Low ESR, High ripple current. Load life of 2000 hours at 105C. Radial lead type : Lead free flow soldering condition correspondence. Adapted to the RoHS directive (2002/95/EC). Specifications Item Category Temperature Range Rated Voltage Range Performance Characteristics - 55 ~ +105C 2.5 ~ 16V 20% at 120Hz, 20C Not more than value of Standard ratings at 120Hz, 20C Not more than value of Standard ratings at 100kHz, 20C Rated Capacitance Range 270 ~ 1000F Capacitance Tolerance tan ESR ( 1) 2) Leakage Current ( Not more than value of Standard ratings. Z+105C / Z+20C Z- 55C / Z+20C 1.25 1.25 (100kHz) After 2 minute's application of rated voltage. 20C Characteristics of Temperature Impedance Ratio Endurance After 2000 hours' application of rated voltage at 105C, capacitors meet the specified value for life characteristics listed at right. Capacitance change tan ESR ( 1) 2) Leakage current ( Within 20% of initial value ( 3) 150% or less of the initial specified value 150% or less of the initial specified value Initial specified value or less Within 20% of initial value ( 3) 150% or less of the initial specified value 150% or less of the initial specified value Initial specified value or less Damp Heat After 1000 hours' application of rated voltage at 60C 90%RH, capacitors meet the specified value for life characteristics listed at right. To comply with recommended conditions for reflow soldering. Pre-heating shall be done at 150 ~ 200C and for 60 ~ 180 sec. Peak temp. is 265C, within 10 sec. Measurement for solder temperature profile shall be made at a point on the terminal nearest where the terminals protrude through the soldering side of PC board. Navy blue print on the case top Capacitance change tan ESR ( 1) 2) Leakage current ( Resistance to Soldering Heat Capacitance change tan ESR ( 1) 2) Leakage current ( Within 10% of initial value ( 3) 130% or less of the initial specified value 130% or less of the initial specified value Initial specified value or less Marking 1 ESR measurements should be made at a point on the terminal nearest the end seal of the capacitor. 2 Conditioning : If there is doubt about the measured result, measurement should be made again after the rated voltage is applied for 120 minutes at the temperature of 105C. 3 Initial value : The value before test of examination of resistance to soldering. Dimensions Capacitance Type numbering system (Example : 4V 560F) Laminated Case Silvered lead Wire Voltage(g:4V) D+0.5 MAX. Taping code P 0.5 6X1 560 LF g d Series Lot. No. L+0.5MAX. 15MIN 4MIN (mm) Size D L P d 8 x 9L 8.0 8.5 3.5 0.6 8 x 12L 10 x 13L 8.0 10.0 11.5 12.5 3.5 5.0 0.6 0.6 Voltage V Code 2.5 e 4 g 6.3 j 10 A 16 C Please refer to page 21 about the end seal configulation. Dimension table in next page. CAT.8100V CONDUCTIVE POLYMER ALUMINUM SOLID ELECTROLYTIC CAPACITORS LF series Standard ratings Rated Voltage (V) (code) Rated Capacitance (F) Case Size DxL (mm) tan Leakage Current (0.2CV)(A) ESR (m) (at 100kHz 20C) Rated ripple (mArms) Part Number 560 680 2.5 (0E) 8x9 8 x 12 8x9 8 x 12 10 x 13 8x9 8 x 12 8 x 12 10 x 13 8x9 8 x 12 10 x 13 8 x 12 10 x 13 8 x 12 10 x 13 0.08 0.08 0.08 0.08 0.08 0.08 0.08 0.08 0.08 0.08 0.08 0.08 0.08 0.08 0.08 0.08 280 340 410 410 500 448 448 544 656 592 592 857 540 940 864 1504 6 6 7 6 6 7 7 6 6 7 7 6 8 7 9 9 4800 5700 5200 6200 6500 5200 5500 6200 6500 5200 5500 6300 4900 5700 4800 5000 PLF0E561MCO1 PLF0E681MDO1 PLF0E821MCO6 PLF0E821MDO1 PLF0E102MDO1 PLF0G561MCO6 PLF0G561MDO1 PLF0G681MDO1 PLF0G821MDO1 PLF0J471MCO6 PLF0J471MDO1 PLF0J681MDO1 PLF1A271MDO1 PLF1A471MDO1 PLF1C271MDO1 PLF1C471MDO1 820 820 1000 560 4 (0G) 560 680 820 470 6.3 (0J) 10 (1A) 16 (1C) 470 680 270 470 270 470 No marked, 1 will be put at 12th digit of type numbering system. : In this case, 6 will be put at 12th digit of type numbering system. Rated Ripple (mArms) at 105C 100kHz Taping specifications are given in page 24. Please refer to page 3 for the minimum order quantity. CAT.8100V |
Price & Availability of PLF0E102MDO1
 |
|
|
|
|
All Rights Reserved © IC-ON-LINE 2003 - 2022 |
| [Add Bookmark] [Contact Us] [Link exchange] [Privacy policy] |
|
Mirror Sites : [www.datasheet.hk]
[www.maxim4u.com] [www.ic-on-line.cn]
[www.ic-on-line.com] [www.ic-on-line.net]
[www.alldatasheet.com.cn]
[www.gdcy.com]
[www.gdcy.net] |